TUSK RC • Firmware Installer
ESP32-C3 (Romeo Mini / DFR1063)
Install or update your controller firmware in your browser — no Arduino IDE required.
Requires Chrome / Edge (desktop)
USB cable required
Install in 4 steps
- Plug your TUSK RC controller into your computer via USB.
- Use Chrome or Edge on desktop.
- Click Install / Update Firmware.
- Select the USB device when prompted and confirm.
Tip: Use a data USB cable (some charge-only cables will not connect).
What this does
- Installs the latest TUSK RC controller software
- Adds bug fixes and new features
- Enables your control modes
- Supports lights, sound, and accessories if included in the firmware
Safe to run
You’ll be asked to confirm the install, and you can unplug after it finishes.
Troubleshooting
Device not showing up?
Try a different USB cable or port. Close Arduino IDE or any Serial Monitor windows.
Force flash mode (ESP32-C3)
Hold BOOT, tap RST, release BOOT, then click Install again.
If you still get stuck, include your OS and browser when contacting support.
Coming soon: one page with installers for Boar / Bison / Ox and accessory modules.